Made from polypropylene, this is a quick and easy way to install waste systems incorporating a push-fit ring seal system. An allowance of a 10mm expansion gap on all push-fit joints is required for the expansion of pipes and fittings in each socket of push-fit systems. Requires no solvent welding or tightening. Manufactured to BS EN 1451-1: 2000 / BS 5254.

Allows access into the waste system. Fits most standard size waste pipe (excluding universal push fit waste). Requires no tightening. A lightweight yet strong and cost-effective option. Apply solvent cement evenly to both surfaces of joint, insert pipe fully into the socket depth and remove surplus cement with a cloth. Allow five minutes to set before handling and twelve hours before testing the system. It is recommended that externally installed ABS waste systems are protected against prolonged exposure to sunlight with exterior gloss paint.

Allows access into the waste system. Fits most standard size waste pipe (excluding universal push fit waste). Requires no tightening. A lightweight yet strong and cost-effective option. Apply solvent cement evenly to both surfaces of joint, insert pipe fully into the socket depth and remove surplus cement with a cloth. Allow five minutes to set before handling and twelve hours before testing the system. It is recommended that externally installed ABS waste systems are protected against prolonged exposure to sunlight with exterior gloss paint.

Allows access into the waste system. Fits most standard size waste pipe (excluding universal push fit waste). A lightweight yet strong and cost-effective option. Apply solvent cement evenly to both surfaces of joint, insert pipe fully into the socket depth and remove surplus cement with a cloth. Allow five minutes to set before handling and twelve hours before testing the system. It is recommended that externally installed ABS waste systems are protected against prolonged exposure to sunlight with exterior gloss paint.

Fits all standard waste pipe (excl. universal push fit waste). Manufactured to BS EN 1455-1:2000 / BS 5255.

For use where access is required at a change of direction.

For use where access is required in a straight section, such as the base of a soil stack.

Converts 80mm downpipes to 110mm.